Produktbeskrivelse
The AT-38OD operates in “On-Demand” mode.
The unit starts to operate when the ignition is on (engine running) and
the battery voltage level is higher than 13.0 volts. Once the unit is
activated, the washer fluid inside its heating chamber will be heated
and kept within pre-determined temperature limits (56 – 60°C). So
there is always hot fluid inside the unit’s heating chamber which can be
used by a driver for cleaning the windshield.
Each time the driver activates the factory installed washer system,
heated washer fluid is applied to the windshield for approximately the
first 3 seconds of spray. Three seconds of the spray delivers
approximately 50-60 cc of fluid that is considered sufficient amount of
fluid for one spray. The next portion of heated washer fluid is available
in 10-20 seconds (depending on ambient conditions).
The unit uses full power of 50 Amps for approximately 30 seconds to
heat the washer fluid to the pre-determined temperature limits (56 – 60°C) and minimal power to keep it within these limits. The unit’s
power consumption is less than 2 Amps per hour at ambient temperature of -18°C.
Once the unit starts to operate (engine is running), it will heat the
washer fluid in approx. 30 seconds. Driver operates the washer
system manually to spray the heated fluid onto the windshield.
Recommended duration of spray is 3 seconds. Driver can spray as
many times as he wants. Best results are achieved when time
intervals between sprays are approximately 20 seconds.
Size: Height: 137 mm, Width: 100 mm Thickness: 43 mm.
The unit starts to operate when the ignition is on (engine running) and
the battery voltage level is higher than 13.0 volts. Once the unit is
activated, the washer fluid inside its heating chamber will be heated
and kept within pre-determined temperature limits (56 – 60°C). So
there is always hot fluid inside the unit’s heating chamber which can be
used by a driver for cleaning the windshield.
Each time the driver activates the factory installed washer system,
heated washer fluid is applied to the windshield for approximately the
first 3 seconds of spray. Three seconds of the spray delivers
approximately 50-60 cc of fluid that is considered sufficient amount of
fluid for one spray. The next portion of heated washer fluid is available
in 10-20 seconds (depending on ambient conditions).
The unit uses full power of 50 Amps for approximately 30 seconds to
heat the washer fluid to the pre-determined temperature limits (56 – 60°C) and minimal power to keep it within these limits. The unit’s
power consumption is less than 2 Amps per hour at ambient temperature of -18°C.
Once the unit starts to operate (engine is running), it will heat the
washer fluid in approx. 30 seconds. Driver operates the washer
system manually to spray the heated fluid onto the windshield.
Recommended duration of spray is 3 seconds. Driver can spray as
many times as he wants. Best results are achieved when time
intervals between sprays are approximately 20 seconds.
Size: Height: 137 mm, Width: 100 mm Thickness: 43 mm.
